Copy Zone

To copy a single Zone:

1. Right-click onto the edge or center of a Zone.
2. Select Copy Zone from right-click menu.
3. By default, the copy mode is Move From Point which requires a first point to be specified, followed by the second point (either by left-click or entered as X,Y coordinates in the command prompt). Alternatively, the move mode can be Relative for which an X, Y translation must be specified.

To copy multiple Zones:

1. Select Copy Zone from the Zones tab.
2. Left-click to select Zones to copy.
3. Hit ENTER or right-click and select Done Selection to start copying.
4. By default, the copy mode is Move From Point which requires a first point to be specified, followed by the second point (either by left-click or entered as X,Y coordinates in the command prompt). Alternatively, the copy mode can be Relative for which an X, Y translation must be specified.

Copy of Zone

The copy of the Zone will have the same Display Settings and Piles In The Zone selected, and Cut-off Elevation and Pile Depth Increment settings as the original Zone it was copied from. The Name and Pile Type Designations will be set to the next unique values so that there are no duplications.