Non-Tapered Piles

H-PILE

The following input parameters are required for defining an H-Pile:

• Type of H-Pile - users can select from 11 pre-defined piles
• Pile Perimeter for Analysis - This is the perimeter that will be used for the skin friction capacity computations. The two options are H Pile Perimeter and Box Perimeter.
• Tip Area for Analysis - This is the bottom area of the pile that will be used for end bearing capacity calculations. The three options are H Pile Area, Box Area, and User Select.

The table below summarizes the properties of the available H-Pile sections.

METRIC

H-Pile Designation	Pile Area (mm2)	Width (mm)	Perimeter (mm)	Box Area (mm2)	Box Perimeter (mm)
HP 360x174	22 200	378	2153	136 468	1478
HP 360x152	19 400	376	2140	133 856	1464
HP 360x132	16 900	373	2122	130 923	1448
HP 360x108	13 800	370	2106	128 020	1432
HP 310x125	15 800	312	1805	97 344	1248
HP 310x110	14 000	310	1793	95 480	1236
HP 310x93	11 800	308	1780	93 324	1222
HP 310x79	9 970	306	1768	91 494	1210
HP 250x85	10 800	260	1491	66 040	1028
HP 250x62	7 980	256	1467	62 976	1004
HP 200x53	6 810	207	1190	42 228	822